How to Reset the Arris BGW210-700 ATT

Reset the Arris BGW210-700 ATT router back to its original factory defaults. This is not a reboot. If you require rebooting a router simply unplug the device for about 30 seconds and plug it back in. Reset deletes all your personalized settings and returns everything back to factory defaults.

To find the reset button on the Arris BGW210-700 ATT router, turn the device around so you're looking at the back panel. Take a little sharp object and press down on the reset button for about 10 sec whereas the router is on. This begins the reset process which can take several minutes or more to complete.

Warning: Resetting a router is a big step. You require to fully reconfiguring the device afterward. Some of the settings that require to be changed after a reset are:

The router's login username and password.

The router's Wi-Fi SSID/network name and password.

If this is a DSL router, you require re-entering the ISP (Internet Service Provider) username and password. Call your ISP for these details.

Any port forwarding, scheduling, or IP addresses you have changed.

Reset the Arris BGW210-700 ATT

To find the reset button on the Arris BGW210-700 ATT router, turn the device around so you're looking at the back panel.

Take a little sharp object and press down on the reset button for about 10 sec while the router is on. This begins the reset process which can take several minutes or more to complete.

Warning: Don't unplug or put off the router during the reset process. Doing this will cause permanent damage to the device.

Remember a reset can erase all your previously changed settings. I recommend exhausting your other troubleshooting methods before resetting a router. How to fix at&t outage map and att email login problems.

How to disable WiFi on AT&T modems

Arris NVG589 (blue interface)

1. Using a pc connected to the AT&T router, open an Internet browser and type 192.168.1.254 to login to the web-based control panel.

2. Enter the password, if needed (the password will be on your gateway unit usually).

3. Then click on Local Network ->WiFi and from WiFi Operation, turn the WiFi OFF.

4. Click Save to apply settings.

Uverse modems (grey interface)

1. Using a computer connected to the AT&T router, open an Internet browser and type 192.168.1.254 to login to the web-based control panel.

2. Enter the password, if needed (the password will be on your gateway unit usually).

3. Choose Wireless. 

4. Under Wireless Interface, choose Disabled from the drop-down list.

5. Click Save to apply settings.

6. A Configuration successful page should seem to reconfirm wireless interface is disabled.

How to contact at&t live chat & at&t bill pay phone number team.